Vpacket Hotwire 5100 Guide de l'utilisateur télécharger pdf (Page 53)

B-1

5100-A2-GB20-00

November 1996

Installing POTS Splitter at

Customer Premises

How to Install the POTS Splitter

The following procedure describes how to wire a HotWire POTS Splitter at a

customer site. It does not specify the specific hardware to use. Consult your

company’s specifications for that information. However, it is recommended that

you use the same type of two-conductor cable that is used for the pole-to-house

connection to make the connection between the Telephone Network Interface

and the POTS splitter. Also, use EIA/TIA Category 3 cable between the DSL card

and the POTS splitter.

Figure B-1 presents a schematic view of the circuit. Figure B-2 illustrates how to

wire the POTS splitter.

Customer

Telephones

Primary

Surge

Protection

(2)

DSL Card

POTS

Splitter

Tip

Ring

Tip

Ring

Network

Demarcation

Point

Subscriber

Loop

496-15024

Figure B-1. Schematic of POTS Splitter Installation

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 59

Pas de commentaire

Vpacket Hotwire 5100 Guide de l'utilisateur Page 53