Vpacket Hotwire 5100 Guide de l'utilisateur télécharger pdf (Page 13)

2-1

5100-A2-GB20-00

November 1996

Installing and Connecting the

Card

Package Contents

The HotWire DSL CO product consists of:

H CO DSL card

H HotWire DSL CO Product Disks

H HotWire DSL POTS Splitter

H User’s guide

Installation Steps

" Procedure

To install the HotWire DSL CO product, follow these steps:

1. Set the I/O base address of the card by setting dual in-line package (DIP)

switches on the card (page 2-2).

2. Set all hardware interrupt request (IRQ) switches to off (page 2-4).

3. Install the card into the PC (page 2-4).

4. Cable the card to the local LAN network (hub) (page 2-6).

5. Cable the card to the POTS splitter (page 2-6).

6. Cable the POTS splitter to the subscriber loop and CO switch (page 2-6).

7. Install the HotWire DSL CO product software (page 2-11).

8. Configure (if necessary) the DSL mode and MAC and IP filter addresses

using the HotWire DSL Central Management Utility as described in

Chapter 4,

Configuring and Managing the Card

9. Configure the SNMP Agent as described in Chapter 5,

Configuring the SNMP

Agent

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 58 59

Pas de commentaire

Vpacket Hotwire 5100 Guide de l'utilisateur Page 13