Vpacket Hotwire 5100 Guide de l'utilisateur télécharger pdf (Page 16)

Installing and Connecting the Card

2-4

5100-A2-GB20-00

November 1996

Setting IRQ Switches to Off

IRQ (hardware interrupt request) DIP switch banks SW2 and SW3 select an IRQ.

IRQs are not used by the CO cards. Set these switches to Off for proper

operation of the card.

496-15017

678

12345

1234

SW2

SW3

Installing the CO Cards in the PC

 Procedure

1. Access the card slots of the PC.

2. Insert a CO card into a vacant 16-bit ISA expansion slot.

3. Observe the SYS LED after the card is inserted. It should blink while a

self-test is in progress and then remain on. If it does not, the card is defective

and should be replaced. (See

LED Status

in Chapter 6 for a description of the

card’s LEDs.)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 58 59

Pas de commentaire

Vpacket Hotwire 5100 Guide de l'utilisateur Page 16