Vpacket 6100 SERIES Guide d'installation télécharger pdf (Page 98)

90 Acme Packet 6100 Hardware Installation and Maintenance Guide

5. Hold the SSD in one hand, and the SATA connector in the other, and gently

disconnect the two. Note that the SATA cable should remain attached to the

motherboard.

Screw

SATA

Connection

to SSD

SATA

Connection

to Motherboard

REAR

FRONT

Bases

Figure 6 - 122: After SSD removal

Replacing the Solid

State Drive

1. Exchange the current SSD for the replacement, then re-attach the SSD to the

SATA cable. The connector is keyed, so make sure the gap in the connector is

lined up with the key in the SSD.

2. Push down on the part of the SATA connect

er attached to the motherboard to

check to make sure the SATA cable is seated properly to the motherboard.

3. Line up the screw mounts on the SSD with the screw bases, and tighten the

scr

ews. Be careful not to over-tighten the screws.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 127 128

Pas de commentaire

Vpacket 6100 SERIES Guide d'installation Page 98