Vpacket Hotwire 5100 Guide de l'utilisateur télécharger pdf (Page 13)

Installation and Setup

2-2

5100-A2-GB21-00

November 1996

Installing the HotWire Diagnostics Utility

" Procedure

To install the Diagnostics Utility:

1. Insert the HotWire Diagnostics Utility and Drivers disk in drive A.

2. Enter Windows and:

If . . .

Select . . .

On the Program Manager window File, then Run.

Using Windows 95 Start, then Run.

3. Type A:\SETUP.EXE and click on OK.

4. Follow the screen instructions for installing the software. When the install

program prompts for a destination directory for the Diagnostics Utility, you

can specify a directory or click on Next to accept the default directory.

5. Click on OK when installation completes.

An icon is created for the utility. You can double-click on the icon to start the utility

when needed.

NOTE:

Some Diagnostics Utilities can interfere with network data so the Diagnostics

Utility menus should be open only when configuring or testing the card.

Preparing the Card

For the HotWire DSL card to operate properly with your PC configuration, you

need to set the following DIP switches:

H I/O Base Address

H IRQ setting

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 44 45

Pas de commentaire

Vpacket Hotwire 5100 Guide de l'utilisateur Page 13